ITDB02-2.8 Module is 2.8" TFT LCD Screen Module with 65K color 320 x 240 resolutions. The controller of this LCD module is ILI9325DS. This is the 8 bit data interface module with 4 wires control interface. Moreover, this module includes the touch screen and SD card socket.
ITDB02-2.8 is supported by UTFT Library.
Hardware
Pin Mapping
Type* |
Description |
|
GND |
G |
Ground |
VCC |
P |
5V Power Supply pin |
NC |
- |
No connection |
RS |
I |
Data/Command selection |
WR |
I |
Write signal enable, low active |
RD |
I |
Read signal enable, low active |
DB8 |
I |
Data Bus |
DB9 |
I |
Data Bus |
DB10 |
I |
Data Bus |
DB11 |
I |
Data Bus |
DB12 |
I |
Data Bus |
DB13 |
I |
Data Bus |
DB14 |
I |
Data Bus |
DB15 |
I |
Data Bus |
CS |
I |
Chip Selection,Low level active |
NC |
- |
No connection |
LED |
P |
Backlight |
NC |
- |
No connection |
DB0 |
- |
No connection(8bit and 16bit mode) |
DB1 |
- |
No connection(8bit and 16bit mode) |
DB2 |
- |
No connection(8bit and 16bit mode) |
DB3 |
- |
No connection(8bit and 16bit mode) |
DB4 |
- |
No connection(8bit and 16bit mode) |
DB5 |
- |
No connection(8bit and 16bit mode) |
DB6 |
- |
No connection(8bit and 16bit mode) |
DB7 |
- |
No connection(8bit and 16bit mode) |
T_CLK |
I |
Touch clock |
T_CS |
I |
Touch chip selection |
T_DIN |
I |
Touch data input |
T_BUSY |
O |
Touch status |
T_DOUT |
O |
Touch data output |
T_IRQ |
O |
Touch interrupt |
SD_SO |
O |
SD MISO |
SD_SCK |
I |
SD SCK |
SD_SI |
I |
SD MOSI |
SD_NSS |
I |
SD NSS |
NC |
- |
No connection |
NC |
- |
No connection |
Documents