Bus Blaster v3

Rp. 629,000
Availability:
Brand: Seeed Studio
Product Code: TOL0023
Qty:     

Bus Blaster v3 is an experimental, high-speed JTAG debugger from Dangerous Prototypes.

Thanks to a reprogrammable buffer, a simple update over USB makes Bus Blaster compatible with many different JTAG debugger types in the most popular open source software.

  • Based on FT2232H with high-speed USB 2.0
  • Buffered interface works with 3.3volt to 1.8volt targets
  • Reprogrammable buffer is compatible with multiple debugger types
  • Compatible with 'jtagkey', 'KT-link' programmer settings in OpenOCD,
  • urJTAG, and more
  • ships with JTAGkey compatible buffer image pre-programmed
  • Should support Serial Wire Debug when available
  • Mini-CPLD development board: self programmable, extra CPLD pins to header
  • Open source (CC-BY-SA)

 

Updates in v3

  • Fitted in a DP8049 (80x49 mm) standard PCB, case available here
  • Added series resistors to input and output pins to protect against damage and noise
  • Swapped FT2232 clock output to CPLD pin with global clock feature for potential logic analyzer mode

 

Each unit is tested before it ships.

Documents

 

This open source hardware and software is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.

If you encounter any problems when using this product, please request technical support in the forum.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating:    Bad            Good